Filter replacement steps

‌Filter replacement steps mainly include the following steps‌:

‌Preparation‌: First, make sure the engine is at operating temperature, lift the vehicle with a jack, apply the handbrake and wedge the front wheels. Make sure you understand the special safety precautions in the owner's manual. ‌

‌Drain the old oil and oil filter‌: Use a 15mm wrench to loosen the oil plug screw counterclockwise to let the old oil flow out. When the oil has almost flowed out, use the oil filter wrench to loosen the oil filter counterclockwise, taking care not to touch the hot exhaust manifold.

‌Replace the oil filter‌: Wipe the base of the filter on the engine with a rag, then apply a film of oil (new or old oil) on the gasket as a sealant. Carefully insert the new oil filter, turn the threads clockwise to align and tighten, but do not overtighten.

‌Fill with new oil‌: Open the oil cap, insert the funnel and inject a certain amount of oil, and pull out the oil dipstick to determine whether it is filled. Replace the oil cap and wipe off any spilled oil.

‌Start the engine‌: Start the engine for a few minutes and then shut it off. Check the dipstick again to make sure the oil level is correct.

You Might Also Like

Send Inquiry