Working Principle Of Transmission System
Compared with manual transmission, the structure of AT transmission system is very different in structure and use. Manual transmission is mainly composed of gears and shafts, and speed and torque are changed through different gear combinations; while AT transmission system is composed of torque converter, planetary gear and hydraulic control system, and speed and torque are changed through hydraulic transmission and gear combination. Among them, torque converter is the most characteristic component of AT transmission system. It is composed of components such as pump wheel, turbine and guide wheel. It directly inputs engine power and transmits torque, and has clutch effect at the same time. Pump wheel and turbine are a pair of working combinations. They are like two fans placed opposite each other. The wind blown by one fan will drive the blades of the other fan to rotate. Wind becomes the medium for kinetic energy transmission. If liquid is used instead of air as the medium for transmitting kinetic energy, the pump wheel will drive the turbine to rotate through the liquid. Then add a guide wheel between the pump wheel and the turbine, and the speed difference between the pump wheel and the turbine can be achieved through the reaction force to achieve speed change and torque change. Since the automatic speed and torque range of the torque converter is not large enough, several rows of planetary gears are connected in series behind the turbine to improve efficiency. The hydraulic control system will automatically control the planetary gears as the engine works, thereby realizing automatic speed and torque change. The automatic shifting of the auxiliary mechanism cannot meet various driving needs, such as parking, reversing, etc., so there is also an intervention device, namely a manual lever, marked P (parking), R (reverse), N (neutral), D (forward), and there are additional gears "2" and "1" in the forward position for starting or going up a slope. Since its speed range is divided into several speed ratio sections, it is stepless only within the specified speed range. Therefore, the AT transmission system is actually an automatic transmission between stepped and stepless. [3]
Hydraulic automatic transmissions are usually of two types: one is a front-mounted rear-drive hydraulic automatic transmission; the other is a front-mounted front-drive hydraulic automatic transmission. The electronic control of the hydraulic automatic transmission receives electrical signal input from various sensors on the vehicle through the powertrain control module, and processes this information according to the vehicle's operating conditions to determine the operating conditions of the hydraulic automatic transmission. According to these operating conditions, the powertrain control module issues instructions to the actuator and implements the following functions: transmission up and down; generally by manipulating a pair of electronic shift solenoid valves to switch between the on/off states; by controlling the solenoid valve through electronic pressure control to adjust the pipeline oil pressure; the torque converter clutch controls the engagement and disengagement time by controlling the solenoid valve, and the engagement feeling of the torque converter lock clutch in some applications.
The automatic transmission mainly controls up and down based on the vehicle speed sensor, the throttle position sensor and the degree to which the driver presses the accelerator pedal.






